Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From £3.29 | From €75.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | A DIY parts package for constructing a backlit 737 autobrake panel. It includes laser-engraved acrylic panel components and smaller MFD/button faceplates; 3D-printed parts are required for a fully functional unit. | A Cessna 172 G1000 side-panel replica for flight-simulation cockpits. Depending on the selected connection version, it is supplied as a panel-only assembly, a programmable unit requiring a controller board, or a pre-programmed USB-ready product. |
| Aircraft | 737 | C172 |
| Aviation category | Airliners | General Aviation |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Not specified | IDC connector: IDC connector on the rear PCB; pin assignments are labelled or provided in a datasheet. 12 V backlighting connector: Separate 12 V connector for panel backlighting; a single-panel product does not include a 12 V adapter. USB: The Plug and Play version is described as USB-ready. |
| Software requirements | Not specified | Programming: Required for the Connect and Play version when connected to a controller board. Configuration files: The Plug and Play version requires installation of the provided configuration files. |
| Physical requirements | 3D-printed parts: Required for a fully functional unit | Controller board: Required for the Connect and Play version. Wiring harness and housing: Not included with the panel-only set. 12 V power adapter: Not included for a single-panel product; required for backlighting when applicable. |
| Hardware compatibility | Not specified | Controller board: The Connect and Play version connects through the rear PCB IDC pins to a controller board. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Listed product dimensions: 8 × 25 × 22 cm Panel face dimensions: 194.5 mm × 207 mm |
| Product weight | Not specified | Weight: 0.5 kg |
| Additional factual details | Product type: DIY construction parts for an autobrake panel Panel materials: Front panel: 3 mm white acrylic; back and mid panels: 2 mm clear acrylic Lighting: Panel components are designed for backlighting; the back panel and mid panel are painted around the edges to reduce light spill Included components: Smaller MFD panel and button faceplates are included MFD PCB update: A small PCB for the MFD panel includes onboard backlighting resistors | Construction: Two acrylic layers: 3 mm lower sheet and 5 mm upper front sheet. Finish: Gray RAL7011 iron-gray paint. Included controls: Annunciators, annunciator boxes, push buttons, rotary knobs, and red On-Off switches are described for the assembly; exact contents vary by selected version. Backlighting: Warm-white backlighting is provided. Panel-only electronics limitation: The Panel Only version does not include electronic components; switches, toggle switches, rotary switches, encoders, or potentiometers must be sourced separately. Knob fitting: Knobs use a D-shaft fitting. SKU: 3100001 |