Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From £3.29 | From €50.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | A DIY parts package for constructing a backlit 737 autobrake panel. It includes laser-engraved acrylic panel components and smaller MFD/button faceplates; 3D-printed parts are required for a fully functional unit. | A Boeing 737 navigation-panel replica for flight-simulation cockpits and training setups. It includes panel controls, annunciators, knobs, buttons, backlighting, and variant-dependent electronics or USB connectivity. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Not specified | Flight simulation software: Preferred flight simulation software; specific simulator versions are not identified. |
| Connections | Not specified | USB: USB-ready connection for the Plug and Play version. Other: IDC connector with dedicated pins is used for the Connect and Play version; connection to a controller board is required. |
| Software requirements | Not specified | Configuration files: Plug and Play version requires installation of the provided configuration files. Programming: Connect and Play version requires programming. Calibration: Any included gauges require calibration through software or firmware. |
| Physical requirements | 3D-printed parts: Required for a fully functional unit | Controller board: Required for the Connect and Play version. 12 V power: A 12 V power adapter is used for backlighting; a single-panel product does not include the adapter. |
| Hardware compatibility | Not specified | Controller boards: Connect and Play version connects to a controller board; gauge components are stated to be compatible with most available controller boards. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Listed dimensions: 3 × 15 × 15 cm Panel size: 146 mm × 152 mm |
| Product weight | Not specified | Weight: 0.2 kg |
| Additional factual details | Product type: DIY construction parts for an autobrake panel Panel materials: Front panel: 3 mm white acrylic; back and mid panels: 2 mm clear acrylic Lighting: Panel components are designed for backlighting; the back panel and mid panel are painted around the edges to reduce light spill Included components: Smaller MFD panel and button faceplates are included MFD PCB update: A small PCB for the MFD panel includes onboard backlighting resistors | Variants: Connection Type options are Connect and Play, Panel Only, and Plug and Play. Construction: Two acrylic sheets are described: a 3 mm lower layer and a 5 mm upper front sheet, painted RAL 7011. Controls: Includes annunciators, annunciator boxes, knobs, buttons, push buttons, and rotary knobs; contents vary by selected version. Backlighting: Warm-white backlighting is provided for the panel and buttons. Panel electronics: The Connect and Play description identifies a PCB; the Panel Only version excludes electronic components. Knobs: Knobs are resin 3D-printed and supplied with a D-shaft fitting. Motors: Where gauges are included, SG90 servo motors or, where specified, 28BY stepper motors with ULN2003 driver boards may be used. |