Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €3.99 | €2.49 |
| Availability | In stock | In stock |
| CockpitSquare overview | The Stepper Motor X27 is a replacement actuator for flight-simulation instrument gauges. It drives gauge needles through controlled increments when used with a compatible stepper-motor board and VID6606/8 microcontroller. | A compact SG90 micro servo motor intended to drive small flight-simulation instruments and other mechanical indicators. The product page specifies 4.8 V operation, 1.8 kg/cm torque, a 25 cm servo cable, and compatibility with controller boards and Arduino-based projects. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Not specified | Connector: Servo connector on a 25 cm cable |
| Software requirements | Simulator support documentation: An installation-instructions download is listed for MSFS, but no specific MSFS version is established. | Calibration: Calibration through software or firmware is required for gauge applications. |
| Physical requirements | Compatible control electronics: Requires a compatible stepper-motor board and VID6606 / 8 microcontroller for instrument-panel operation. Intended mechanical use: Designed to move needles in flight instruments and gauges. | Operating voltage: 4.8 V Controller: A compatible flight-control or microcontroller board is required for instrument applications. |
| Hardware compatibility | Replacement motor compatibility: Designed as a replacement for XC5.168 and X15.168 stepper motors. Control hardware: Compatible with the VID6606 / 8 microcontroller and stepper-motor board. | Controller boards: Most available controller boards; Arduino systems are explicitly mentioned. Arduino: Arduino systems |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Dimensions: 4 × 4 × 4 cm | Dimensions: 23 × 12.2 × 29 mm Additional listed dimensions: 4 × 4 × 4 cm; this conflicts with the more specific dimensions stated in the product description. |
| Product weight | Weight: 0.1 kg | Weight: 9 g Additional listed weight: 0.1 kg; this conflicts with the 9 g specification in the product description. |
| Additional factual details | SKU: 5000041 Product type: Replacement stepper motor for flight instruments and gauges. Function: Converts electronic impulses into controlled mechanical needle movement when paired with compatible control electronics. Listed price: €3.99 excluding tax Stock status: 19 in stock at the time the page was indexed. | Torque: 1.8 kg/cm at 4.8 V Speed: 0.1 seconds per 60 degrees Operating temperature: 0 to 55 °C Cable length: 25 cm SKU: 5000038 Intended applications: Flight instruments, cockpit simulators, RC aircraft, and custom Arduino projects. |