Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | $2.95 | From €6.50 |
| Availability | In stock | In stock |
| CockpitSquare overview | A CD74HC4067-based breakout board that multiplexes or demultiplexes up to 16 bidirectional analog or digital channels. It is intended for DIY electronics projects requiring sensor, TTL serial, I2C, SPI, or similar signal routing. | A stepper-motor controller PCB for flight-simulation projects, designed to control up to four X27 stepper motors. It is sold in PCB-only, component-included, and soldered/plug-and-play variants, with the latter described as USB-ready. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Preferred flight simulation software: Supported in the plug-and-play variant; specific simulator versions are not stated |
| Connections | Not specified | USB: Available on the plug-and-play variant; described as USB-ready |
| Software requirements | Not specified | Configuration files: Provided configuration files must be installed for the plug-and-play variant Programming: Required for the Connect and Play variant |
| Physical requirements | Supply voltage: 2V to 6V operation | Stepper motors: Up to four X27 stepper motors |
| Hardware compatibility | Not specified | X27 stepper motors: Supports up to four motors Controller board: The Connect and Play and soldered PCB variants connect to a controller board |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Dimensions listed in additional information: 0.2 × 10 × 10 cm Compact dimensions stated in description: 28 mm × 43.5 mm |
| Product weight | Not specified | Weight: 0.05 kg |
| Additional factual details | Multiplexer channels: 16 channels; routes the common signal pin to one of 16 channel pins Signal types: Supports analog and digital signals; signal voltage must not exceed VCC Control interface: Uses four digital address-select inputs, S0-S3; up to 16 sensors can be connected using five pins Signal routing: Bidirectional switching; suitable for TTL-level serial data and potentially I2C or SPI arrangements On resistance: 70 Ohms at 4.5V Switching behavior: 6ns break-before-make at 4.5V Operating temperature: -55C to 125C Enable control: Enable pin can disconnect the common pin when driven high Package contents: One CD74HC4067 16-channel analog/digital MUX breakout board | SKU: SB-EL-VIDX27ST Variants: PCB + electronic components, PCB only, or soldered PCB (Connect and Play) Included components: Complete packages include a VID6606 microcontroller, 1 kΩ resistor, 100 nF capacitor, and 22 uF capacitor Multiplexer: The product description states that the plug-and-play option includes a multiplexer connection Power supply: Single-panel products do not include a 12V adapter; the adapter is used for panel backlighting PCB variants: PCB Only is a bare PCB; PCB + Electronic Components includes parts for soldering; Soldered PCB is soldered and tested Price: €6.50–€15.00 excluding tax Dimensions limitation: The page provides two different dimension specifications; their applicability is not clarified Plug-and-play status: The soldered/plug-and-play option is described as pre-programmed and ready to connect by USB |