Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | CHF 55.00 | £1.48 |
| Availability | Not specified | In stock |
| CockpitSquare overview | A fifth-generation USB main printed circuit board intended as an electronic replacement or control component for a compatible flight-simulation hardware setup. The product page identifies it as a standalone PCB and lists a price excluding VAT. | A printed circuit board intended for use inside 737DIYSIM’s Replica Dual Colour Korry Annunciators. It provides connections for two tactile LED switches and separate ground, button, top-LED, and bottom-LED lines. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Interface: USB | Not specified |
| Software requirements | Not specified | Not specified |
| Physical requirements | Not specified | Required tactile LED switches: 2 tactile LED switches; top and bottom switches may use different colours. Required header pins: 4 male header pins. Required mounting screws: 2 M2.5x5 mm dome-head screws. LED resistors: An appropriate resistor is required for each LED colour. |
| Hardware compatibility | Not specified | Compatible annunciator enclosure: 737DIYSIM Replica Dual Colour Korry Annunciators. Header pin functions: GND, Button/SW, Top LED, Bottom LED. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | Listed price: USD $63.80 ex VAT | LED voltage guidance: Orange LED: 1.9 V; yellow LED: 2.1 V; green LED: 3 V; white LED: 3.2 V. SKU: AL23DKPV1A-L2B Listed price: £1.48 |