Compare Hardware

Compare the details. Find your fit.

2 products

Side-by-side comparison

Show differences only

5th Generation USB main PCB

Pro Flight Trainer

5th Generation USB main PCB

CHF 55.00

A330/A340 FCU Interface Board, LAN

Cockpit Concept

A330/A340 FCU Interface Board, LAN: category illustration, not the specific product

€649.00

In stock

AI insights

Buyer advice	Preparing AI insights

Overview
Price	CHF 55.00	€649.00
Availability	Not specified	In stock
CockpitSquare overview	A fifth-generation USB main printed circuit board intended as an electronic replacement or control component for a compatible flight-simulation hardware setup. The product page identifies it as a standalone PCB and lists a price excluding VAT.	A LAN-connected interface board for integrating an A330/A340 flight control unit (FCU) with JeeHell FMGS. It provides connections for FCU data, discrete signals, illumination, and power, and requires separate 5 V board power.
Aircraft	Not specified	A340A330
Aviation category	Universal / Generic	Airliners
Compatibility & connections
Supported simulators	Not specified	JeeHell FMGS: JeeHell FMGS
Connections	Interface: USB	LAN / Ethernet: Ethernet connection to the local network Power: 5 V DC power supply
Software requirements	Not specified	JeeHell FMGS: Cockpit Concept hardware support via CockpitConcept.dll Cockpit Connect: Required for configuration and communication
Physical requirements	Not specified	Board power supply: Separate stable 5 V supply Wiring and FCU connections: Requires connection to an A330/A340 FCU and associated power, illumination, data, and discrete-signal wiring
Hardware compatibility	Not specified	Aircraft FCU: A330/A340 FCU
Simulator add-on compatibility	Not specified	JeeHell FMGS: JeeHell FMGS hardware support
Dimensions & details
Product dimensions	Not specified	Not specified
Product weight	Not specified	Not specified
Additional factual details	Listed price: USD $63.80 ex VAT	Network addressing: Uses DHCP by default; the assigned IP address can be configured through the board's network interface. Signal connections: Supports FCU power, display backlight, integral backlight, mode illumination, discrete inputs and outputs, data in, and data out. Electrical guidance: Display backlight may use 0–5 V, integral backlight 0–28 V, and mode illumination 0–6.3 V. Installation safety: Cables should only be connected with all power supplies turned off.