Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €109.00 | £3.50 |
| Availability | Not specified | Not specified |
| CockpitSquare overview | A panel-mount, three-position toggle switch with magnetically held momentary positions, solenoid control circuitry, and SPDT contacts. It is intended for flight-simulation cockpits, panels, and DIY or microcontroller-based simulator projects. | A heavy-duty ON/OFF/ON toggle switch intended for flight-simulator MIP and overhead panel builds. The product includes a mounting nut and has a stated 11.5 mm mounting-hole requirement. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Terminal connector: 6P 2.0 mm DIP header with PH connector; supplied with a 15 cm wire-to-board connector | Not specified |
| Software requirements | Not specified | Not specified |
| Physical requirements | Power supply: Variant-dependent: 5.0–5.5 V DC for the 5 V variant, or 12 V DC ±5% for the 12 V variant Panel mounting: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm and recommended minimum 1.5 mm Electrical installation: Requires DC wiring, shared ground with the interface or microcontroller, ARM control input(s), and pull-up resistor(s) for ON1/ON2 outputs | Mounting hole diameter: 11.5 mm |
| Hardware compatibility | Microcontroller-based simulator systems: Suitable for MobiFlight and similar microcontroller-based systems; interface-specific suitability must be evaluated by the user Opencockpits IOCards: Potentially incompatible because the solenoid and switch circuits share the same ground | Not specified |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Mounting and panel dimensions: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm; recommended minimum panel thickness 1.5 mm; throw angle 2 × 18° Operating temperature: 0–40 °C | Base dimensions: 29.5 × 13.5 mm |
| Product weight | Not specified | Not specified |
| Additional factual details | Switch function: The listed standard configuration, part 10-301, uses (ON)-OFF-(ON): the center position is maintained and both outer positions are momentary, spring-loaded, and magnetically held. Electrical contacts: Single Pole Double Throw (SPDT) contacts; microswitch contact rating DC 30 V, 0.1 A. Solenoid control: Two holding solenoids are independently controlled through ARM1 and ARM2 inputs; each solenoid position releases when its ARM input returns LOW. Mechanical life: Minimum 10,000 cycles. Product status: The product page marks the item out of stock. Reference: Reference/part number 10-301 is shown for the standard switch configuration. Safety and intended use: For indoor, DC-powered simulator and DIY applications; not designed, tested, or certified for real aircraft flight-deck equipment or safety-critical systems. | Switch positions: ON/OFF/ON Intended application: MIP and overhead simulator panels Included item: 1 × ON/OFF/ON switch with mounting nut Reference: HDSONOFFON Condition: New Listed price: £3.50, excluding tax as displayed |