Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €480.00 | From £7.70 |
| Availability | Out of stock | In stock |
| CockpitSquare overview | A physical simulator module based on the Honeywell KAP 140 two-axis digital autopilot with altitude preselect. It provides autopilot mode controls, annunciators, altitude and barometric-setting knobs, and connects through a Radio Stack Controller board. | A DIY Boeing 737-modeled Mode Control Panel (MCP) assembly for flight-simulation cockpits. The product uses a dedicated PCB with integrated controls, displays, Korry switches, LEDs, and Raspberry Pico-based electronics, with assembly and some soldering required. |
| Aircraft | Not specified | 737 |
| Aviation category | Universal / Generic | Airliners |
| Compatibility & connections | ||
| Supported simulators | Not specified | Flight simulators: Different simulators |
| Connections | Module-to-controller connection: 26-pole flat cable with connectors to the Radio Stack Controller board | USB: Single USB cable for the PCB Other: 12V DC pin header for backlighting |
| Software requirements | Simkits driver and connection software: Required software is referenced, but the exact package and supported simulator versions are not specified on the product page. | Mobiflight: Pre-programmed Mobiflight options are provided |
| Physical requirements | Radio Stack Controller board: Required to connect the module to a PC. Mounting hardware: A Mounting Set or Radio Stack Cabinet is required to mount the module. | Assembly: DIY assembly required Soldering: Some through-hole soldering required for 7-digit displays and encoders 3D printing: Combined rotary switch 3D prints are excluded from the complete DIY Build Kit |
| Hardware compatibility | Radio Stack Controller board: Required controller hardware for PC connection. | 737SS cockpit: Fits the 737SS MCP orifice 737DS cockpit: Fits with very minor hole modification |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Width: 160 mm / 6.3 in Depth: 50 mm / 1.968 in Height: 44 mm / 1.732 in | Not specified |
| Product weight | Weight: 0.3 kg | Not specified |
| Additional factual details | Product basis: KAP 140 two-axis autopilot with altitude preselect operation; rate-based digital autopilot. Controls and indicators: Includes pitch- and roll-axis annunciators, autopilot engage/disengage, heading, altitude, navigation, approach, back-course, vertical-trim controls, and altitude/barometric-setting rotary knobs. Availability: Out of stock at the time of page capture. SKU: 102507 | Electronics: Single SMD 4-layer PCB with onboard Raspberry Pico, multiplexers, shift registers, and LEDs Controls: Includes 7-digit displays, 6 encoders, a 12-position rotary switch, 5 mini ON/OFF toggle switches, and 14 Korry button cases in the listed budget options A/T switch: Manual standard switch; not magnetically held Release: V14 public release dated June 6, 2024 Safety voltage limits: Maximum 5V DC for the Arduino and 12V DC for backlighting |