Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | $499.00 $599.00 | €54.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | An upgrade kit for CLS-60 force-feedback yoke owners, intended to increase pitch and roll force capability without replacing the complete yoke. It includes a 120N motor, mounting frame, PCB board, and connector wire, with stated support for several flight simulators. | An electronics and housing upgrade kit for existing VKB Gunfighter Mk.I and Mk.II bases. It updates the internal electronics and metal housing to Gunfighter Mk.III specification and includes sensor-related components, a cable, and a casing. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Microsoft Flight Simulator: 2020 and 2024 X-Plane: 11 and 12 Prepar3D: V4.5.11 and higher | Not specified |
| Connections | Not specified | Not specified |
| Software requirements | Supported simulator versions: Microsoft Flight Simulator 2020 and 2024; X-Plane 11 and 12; Prepar3D V4.5.11 or later | Not specified |
| Physical requirements | Required base hardware: CLS-60 yoke Installation: Existing components must be swapped using the provided instructions | Existing base required: VKB Gunfighter Mk.I or Gunfighter Mk.II base Configuration confirmation: Customer must provide a picture of the gimbal after ordering so the correct variant can be supplied |
| Hardware compatibility | CLS-60: Compatible upgrade base | Compatible equipment: VKB Gunfighter Mk.I and Gunfighter Mk.II |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Not specified | Product weight: 200 g |
| Additional factual details | Maximum pitch force: 120N (27 lb) Maximum roll force: 8Nm (5.9 lb-ft) Included motor: 120N motor Included mounting component: Custom mounting frame Included electronics: 120N PCB board Included wiring: Motor-to-board connector wire Warranty: 1-year warranty, with an option to extend by an additional 3 years Seller location restriction: U.S. addresses only Seller identity: SG SimTech Pte Ltd | Upgrade target: Updates existing Gunfighter Mk.I/II internal electronics and metal housing to Gunfighter Mk.III specification Included components: Y-sensor PCB, cable, and casing with X-sensor PCB pre-installed Excluded component: Dust Cover Kit is not included and is available separately Availability: Out of stock at the time of page access |