Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €20.00 | From £7.70 |
| Availability | In stock | In stock |
| CockpitSquare overview | A Boeing 737 AFDS flight-simulator panel with acrylic construction, controls, annunciators, and backlighting. Depending on the selected version, it is sold as a panel-only set, a controller-board-connected unit requiring programming, or a pre-programmed USB-ready unit. | A DIY Boeing 737-modeled Mode Control Panel (MCP) assembly for flight-simulation cockpits. The product uses a dedicated PCB with integrated controls, displays, Korry switches, LEDs, and Raspberry Pico-based electronics, with assembly and some soldering required. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Flight simulation software: Preferred flight simulation software; specific simulators are not named | Flight simulators: Different simulators |
| Connections | USB: Available on the Plug and Play version; USB-ready Proprietary: IDC connector on the PCB for Connect and Play configuration Other: Dedicated 12-volt backlighting connector; single-panel products do not include a 12V adapter | USB: Single USB cable for the PCB Other: 12V DC pin header for backlighting |
| Software requirements | Configuration files: Provided configuration files must be installed for the Plug and Play version Programming: Required for the Connect and Play version | Mobiflight: Pre-programmed Mobiflight options are provided |
| Physical requirements | Controller board: Required for the Connect and Play version 12V power adapter: Required for panel backlighting; not included with a single-panel product | Assembly: DIY assembly required Soldering: Some through-hole soldering required for 7-digit displays and encoders 3D printing: Combined rotary switch 3D prints are excluded from the complete DIY Build Kit |
| Hardware compatibility | Controller board: Compatible in the Connect and Play configuration via the PCB IDC connector; specific board models are not named | 737SS cockpit: Fits the 737SS MCP orifice 737DS cockpit: Fits with very minor hole modification |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Listed dimensions: 5 × 10 × 50 cm | Not specified |
| Product weight | Weight: 0.1 kg | Not specified |
| Additional factual details | Construction: Two precision-cut acrylic sheets: 3 mm lower layer and 5 mm upper front layer Finish: Boeing Gray / Iron Gray, RAL 7011 Lighting: Warm-white backlighting with red, yellow, or amber illuminated buttons and annunciators Panel-only contents: Front and back panels, annunciators, knobs, and switch guards; electronic components are excluded Knobs: Resin 3D-printed knobs with D-shaft fitting Variants: Connection Type options are Connect and Play, Panel Only, and Plug and Play | Electronics: Single SMD 4-layer PCB with onboard Raspberry Pico, multiplexers, shift registers, and LEDs Controls: Includes 7-digit displays, 6 encoders, a 12-position rotary switch, 5 mini ON/OFF toggle switches, and 14 Korry button cases in the listed budget options A/T switch: Manual standard switch; not magnetically held Release: V14 public release dated June 6, 2024 Safety voltage limits: Maximum 5V DC for the Arduino and 12V DC for backlighting |