Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €10.00 | From £12.12 |
| Availability | In stock | In stock |
| CockpitSquare overview | Variant-based sets of replica Boeing 737 annunciator boxes for overhead, aft-overhead, MIP, pedestal, or complete cockpit configurations. Options include panel-only, connect-and-play, and plug-and-play versions, with some variants requiring separate electronics, controller-board programming, or configuration files. | A DIY Boeing 737 six-pack display component product comprising selectable PCB and lens configurations. Depending on the selected option, it provides LED backlighting, ALPS soft-press switches, and engraved lenses for constructing 737 cockpit display units. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Flight simulation software: Generic; no specific simulator version identified | Not specified |
| Connections | USB: Available on the Plug and Play variant; USB-ready | Not specified |
| Software requirements | Configuration files: Required for the Plug and Play variant Programming: Required for the Connect and Play variant Calibration: Required for gauge variants when applicable | Not specified |
| Physical requirements | Controller board: Required for the Connect and Play variant Electronic components: Not included with the Panel Only variant; switches and related components must be purchased separately | Not specified |
| Hardware compatibility | IDC connector pins: Connect-and-play version connects through IDC connector pins on the back of the PCB SG90 servo motors: Gauge variants use SG90 servo motors 12V power adapter: Required for powering backlighting in a custom daisy-chained setup; not included with single-panel products | Pokeys card: Explicitly listed as suitable for the Common Anode PCB version. Arduino: Explicitly listed as suitable for the Common Ground PCB version using digital pins. Karl’s Breakout Board (BOB): Supported with the Common Anode and Common Ground PCB versions, with different interface arrangements. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Dimensions: 15 × 13 × 26 cm | Not specified |
| Product weight | Weight: 0.01 kg | Not specified |
| Additional factual details | Available set selections: After Overhead, MIP, Overhead, and Pedestal Overhead package quantity: 101 annunciator boxes Aft-overhead package quantity: 20 annunciator boxes MIP package quantity: 19 annunciator boxes Pedestal package quantity: 11 annunciator boxes Panel construction: Engraved glass infills are included in the described package options Knobs: Resin 3D-printed knobs with D-shaft fitting, where included Stepper motor option: Some specified gauges use 28BY stepper motors with a ULN2003 driver board SKU: SB-B7M-ANNBOXSE Variant dependency: The page describes Panel Only, Connect and Play, and Plug and Play versions; inclusions and requirements differ by selection | Product configuration: The product page offers a complete DIY set, PCB-only options, and lens options with or without non-slip film. Complete DIY set contents: The complete set includes two switch PCBs, two LED PCBs, and two FO & CPT lenses with non-slip film. Switches: The switch backplate uses four ALPS soft-press buttons. LEDs: The LED backplate provides two LEDs per caption; the listed LEDs are white SMD LEDs. Lenses: Lenses are made from 3 mm orange perspex and may include non-slip film. PCB variants: Common Anode and Common Ground PCB versions are offered. The Common Ground version includes onboard resistors for 5 V operation. Build files: STL build files are available through the linked build guide. Listed price: The page lists a sale price from £12.12, depending on product selection. |