Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €170.00 | From £14.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | A replica TACAN cockpit panel modeled on Bendix KFS TACAN controls for home cockpit and flight-training setups. Depending on the selected variant, it is available as a panel-only assembly, a controller-connected unit requiring programming, or a pre-programmed USB-ready version. | A DIY Boeing 737 multi-radio panel kit for simulator cockpit builders. Depending on the selected option, it may include panel parts, a PCB, electrical components, displays, resin parts, or a complete panel set, while requiring builder-supplied electronics in some configurations. |
| Aircraft | Not specified | 737 |
| Aviation category | Universal / Generic | Airliners |
| Compatibility & connections | ||
| Supported simulators | Flight simulation software: The product page states compatibility with preferred or common flight simulation software, without naming specific simulator products or versions. | Not specified |
| Connections | IDC connector: The Connect and Play variant connects through IDC connector pins on the rear PCB to a controller board. USB: The Plug and Play variant is described as USB-ready. 12V connector: The panel backlighting uses a dedicated 12V connector; a single-panel product does not include a 12V adapter. | Not specified |
| Software requirements | Configuration files: The Plug and Play variant requires installation of the provided configuration files. Programming: The Connect and Play variant requires programming after connection to a controller board. | Simulator/add-on verification: PMDG737 and X-Plane support not yet verified |
| Physical requirements | 12V power adapter: Required for backlighting, but not included with a single-panel product; one adapter can power a daisy-chained cockpit setup. Controller board: Required for the Connect and Play variant. | Configuration-dependent electronics: The Complete Set requires an Arduino or Breakout Board; Arduino is not included with the PCB + Electrical Components option. |
| Hardware compatibility | Controller board via IDC: The Connect and Play variant is intended to connect to a controller board through the PCB's IDC connector pins. | LED connection type: Standard cathode LEDs; LEDs must connect to Arduino digital/analogue pins and are not compatible with BOB shift-register outputs. |
| Simulator add-on compatibility | Not specified | PMDG 737: Not yet verified |
| Dimensions & details | ||
| Product dimensions | Overall product dimensions: 7 × 16 × 4 cm Panel dimensions: 53 mm × 57 mm | Not specified |
| Product weight | Product weight: 0.2 kg | Not specified |
| Additional factual details | Product type: Replica TACAN panel modeled on Bendix KFS TACAN controls. Backlighting: Warm white backlighting is provided for the panel and buttons. Display: Red 7-segment displays are used for navigation readouts. Finish: Matte black finish. Controls: Potentiometer controls have a non-clicking Off position. Variants: Connection Type options are Connect and Play, Panel Only, and Plug and Play. Panel Only contents: Includes front and back panels, annunciators, knobs, and switch guards; electronic components are excluded. | Product type: DIY kit with selectable configurations Radio presets: VHF1, VHF2, VHF3, HF1, HF2, and AM Available options: Complete Set; Panel Set; PCB Only; PCB + Electrical Components; Resin Parts Assembly: Minimal through-hole soldering is required. Resin parts contents: Knobs, Dzus fasteners, and spacers Dzus fasteners: Four replica fasteners are included without screws; M4 x 14 mm countersunk black screws are recommended. Listed price: From £14.00 sale price |