Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €16.00 | CHF 55.00 |
| Availability | Not specified | Not specified |
| CockpitSquare overview | A fully assembled 32-output LED driver expansion board for microcontrollers. It uses a serial shift-register interface, supports common-anode LED configurations, and is documented for integration with Mobiflight. | A fifth-generation USB main printed circuit board intended as an electronic replacement or control component for a compatible flight-simulation hardware setup. The product page identifies it as a standalone PCB and lists a price excluding VAT. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Control interface: Serial shift-register interface using clock, data-in, latch and optional output-enable pins Power input: VDD: 3.3–5 V DC; VLED: up to 17 V DC | Interface: USB |
| Software requirements | Mobiflight: Mobiflight integration is documented; configure the board as a Shift Register device | Not specified |
| Physical requirements | Microcontroller or compatible digital serial-output device: Required; examples include Arduino, Arduino-compatible boards and Raspberry Pi LED configuration: Common-anode LED arrangement Electrical and electronics knowledge: Setup requires knowledge of DC electricity, electronics, embedded systems and serial interfaces | Not specified |
| Hardware compatibility | Microcontroller boards: Devices with digital outputs supporting a serial interface, including Arduino, Arduino-compatible boards and Raspberry Pi | Not specified |
| Simulator add-on compatibility | Mobiflight: Integration guide provided; the board is configured as a Mobiflight Shift Register PMDG Boeing 737 aircraft addon: Used as an example in the supplied Mobiflight integration guide, not established as a general product requirement | Not specified |
| Dimensions & details | ||
| Product dimensions | Board thickness: 1.6 mm | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | LED outputs: 32 outputs per board from two driver chips Current limiting: Approximately 18 mA per output; an external resistor may not be required depending on the LEDs and supply configuration Dimming: Output-enable input can be used for PWM LED intensity control Cascading: Boards can be cascaded through the serial-out header Board revision: Datasheet applies to board revision 2.1; fully assembled Included hardware: Fully assembled circuit board, jumper, wiring connectors and four PCB standoffs are listed as included; optional connector lead availability is also stated Environmental use: Indoor use only; keep away from water and high humidity | Listed price: USD $63.80 ex VAT |