Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €70.00 | £48.78 |
| Availability | In stock | In stock |
| CockpitSquare overview | A Boeing 737 center-gauge and yaw-damper MIP panel replica made from painted acrylic sheets, with annunciators, knobs, buttons, and—depending on the selected version—a servo-driven backlit yaw-damper gauge. Options include panel-only, controller-connected, and pre-programmed USB-ready configurations. | A set of structural base panels for constructing a single-seat Boeing 737 MIP replica. The panels attach to a full-size MIP baseboard and provide standardized openings for mounting cockpit face panels. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Flight simulation software: Generic support stated for the Plug and Play version; no specific simulator names or versions identified | Not specified |
| Connections | USB: Plug and Play version is USB-ready Proprietary: Connect and Play version connects through IDC connector pins on the rear PCB to a controller board Other: Panel Only version has no electronic connection supplied; electronic components are excluded | Not specified |
| Software requirements | Configuration files: Provided configuration files must be installed for the Plug and Play version Programming: Required for the Connect and Play version Calibration: Gauge calibration must be performed through software or firmware | Not specified |
| Physical requirements | Controller board: Required for the Connect and Play version Electronic components: Panel Only version requires separately purchased switches, toggle switches, rotary switches, encoders, or potentiometers 12V power adapter: Not included with single-panel products; used for backlighting in a daisy-chained setup | Required mounting structure: Full-size MIP baseboard Assembly tools: A screwdriver and other tools may be required |
| Hardware compatibility | Controller boards: The gauge's SG90 servo motors are stated to be compatible with most available controller boards SG90 servo motors: Gauge uses SG90 servo motors; one or two are pre-mounted per unit | Not specified |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Panel size: 103 mm × 351 mm; third dimension not stated Catalog-listed dimensions: 5 × 5 × 8 cm; page does not clarify the measurement basis | Not specified |
| Product weight | Weight: 0.2 kg | Not specified |
| Additional factual details | Construction: Two acrylic sheets: 5 mm lower layer and 3 mm upper front layer Finish: Painted Boeing gray, RAL 7011 iron gray Controls: Annunciators, annunciator boxes, knobs, push buttons, and rotary controls are included in the described replica Yaw-damper gauge: Servo-driven and warm-white backlit in the Connect and Play and Plug and Play versions PCB: No PCB is included in the described panel replica Knob fitting: Knobs use a D-shaft fitting Gauge alternatives: Where specified, 28BY stepper motors with a ULN2003 driver board may be used | Material and finish: Usually 3 mm grey acrylic, primed and painted grey Included pieces: Five main panels and one standby instrument blank, six pieces total Purpose: Forms the basic structure and shape of the 737SS MIP and provides standardized rectangular cutouts SKU: 7S23MBPV1A-K6A Version history: v1 dated 01/01/2023 Price shown: £48.78 |