Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | A$130.00 | €89.00 |
| Availability | In stock | Not specified |
| CockpitSquare overview | A functioning mechanical wing-fold switch assembly for an F/A-18 cockpit simulation setup. It provides tactile lever movement, mounts with two M4 screws, and requires an F18 Right Control Board or a custom controller for operation. | A panel-mount, two-position SPDT toggle switch with one maintained position and one momentary position that can be held magnetically by an integrated solenoid. It is intended for flight-simulation cockpit panels and DIY electronics installations. |
| Aircraft | F/A-18 | 737 |
| Aviation category | Military Aircraft | Airliners |
| Compatibility & connections | ||
| Supported simulators | DCS World: Plug-and-play operation requires the F18 Right Control Board. | Microsoft Flight Simulator X: Microsoft Flight Simulator X MSFS 2020: Microsoft Flight Simulator 2020 Prepar3D: P3D ProSim: Prosim 738 Other: Mobiflight with FSUIPC |
| Connections | Other: Custom-controller wiring uses GND and four input pins. | Terminals: 5-position 2.54 mm DIP header and KF2510 connector Power and control pins: GND, VCC, ARM, ON and OFF pins |
| Software requirements | Not specified | Mobiflight: Required for the documented Mobiflight configuration FSUIPC: Required for the documented Mobiflight configuration Prosim: Required for the documented Prosim configuration |
| Physical requirements | Mounting: Requires two M4 screws into the unit body. | DC power supply: 5.0–5.5 V DC for the 5 V variant, or 12 V DC ±5% for the 12 V variant Panel installation: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm; recommended minimum 1.5 mm External pull-up: Required for the open-drain ON and OFF outputs unless the interface provides an internal pull-up Electrical installation: Installation and wiring require knowledge of DC electrical circuits |
| Hardware compatibility | F18 cockpit panels: Compatible with F18 cockpit panels. F18 Right Control Board: Required for plug-and-play operation. | Mobiflight module: Supported in the documented configuration Arduino Mega: Used in the documented Mobiflight configuration Pokeys I/O card: Supported in the documented Prosim configuration |
| Simulator add-on compatibility | Not specified | PMDG 737NG: Documented with Mobiflight and FSUIPC Prosim 738: Documented for Boeing 737 aircraft avionics |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | Construction: Full mechanical wing-fold assembly with authentic tactile action. Finish: Supplied raw and unpainted for custom finishing. Fulfillment: In stock; items are built to order. Price shown: 130.00 Australian dollars on the consulted page. | Electrical contact type: Single Pole Double Throw (SPDT) Switch function: ON-(ON): one maintained position and one momentary spring-loaded position Solenoid function: The momentary position is magnetically held by a small holding solenoid Reference: 10-201 Variants: 10-201 standard lever with brass bushing; 10-202 locking lever with stainless-steel bushing Throw angle: 30 degrees Operating temperature: 0–40 °C Mechanical life: Minimum 10,000 cycles Solenoid electrical life: Minimum 10,000 operating hours Availability: In stock; 9 items shown on the product page Safety limitation: Not designed, tested or certified for real aircraft flight-deck equipment or safety-critical applications |