Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €109.00 | A$130.00 |
| Availability | Not specified | In stock |
| CockpitSquare overview | A panel-mount, three-position toggle switch with magnetically held momentary positions, solenoid control circuitry, and SPDT contacts. It is intended for flight-simulation cockpits, panels, and DIY or microcontroller-based simulator projects. | A functioning mechanical wing-fold switch assembly for an F/A-18 cockpit simulation setup. It provides tactile lever movement, mounts with two M4 screws, and requires an F18 Right Control Board or a custom controller for operation. |
| Aircraft | Not specified | F/A-18 |
| Aviation category | Universal / Generic | Military Aircraft |
| Compatibility & connections | ||
| Supported simulators | Not specified | DCS World: Plug-and-play operation requires the F18 Right Control Board. |
| Connections | Terminal connector: 6P 2.0 mm DIP header with PH connector; supplied with a 15 cm wire-to-board connector | Other: Custom-controller wiring uses GND and four input pins. |
| Software requirements | Not specified | Not specified |
| Physical requirements | Power supply: Variant-dependent: 5.0–5.5 V DC for the 5 V variant, or 12 V DC ±5% for the 12 V variant Panel mounting: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm and recommended minimum 1.5 mm Electrical installation: Requires DC wiring, shared ground with the interface or microcontroller, ARM control input(s), and pull-up resistor(s) for ON1/ON2 outputs | Mounting: Requires two M4 screws into the unit body. |
| Hardware compatibility | Microcontroller-based simulator systems: Suitable for MobiFlight and similar microcontroller-based systems; interface-specific suitability must be evaluated by the user Opencockpits IOCards: Potentially incompatible because the solenoid and switch circuits share the same ground | F18 cockpit panels: Compatible with F18 cockpit panels. F18 Right Control Board: Required for plug-and-play operation. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Mounting and panel dimensions: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm; recommended minimum panel thickness 1.5 mm; throw angle 2 × 18° Operating temperature: 0–40 °C | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | Switch function: The listed standard configuration, part 10-301, uses (ON)-OFF-(ON): the center position is maintained and both outer positions are momentary, spring-loaded, and magnetically held. Electrical contacts: Single Pole Double Throw (SPDT) contacts; microswitch contact rating DC 30 V, 0.1 A. Solenoid control: Two holding solenoids are independently controlled through ARM1 and ARM2 inputs; each solenoid position releases when its ARM input returns LOW. Mechanical life: Minimum 10,000 cycles. Product status: The product page marks the item out of stock. Reference: Reference/part number 10-301 is shown for the standard switch configuration. Safety and intended use: For indoor, DC-powered simulator and DIY applications; not designed, tested, or certified for real aircraft flight-deck equipment or safety-critical systems. | Construction: Full mechanical wing-fold assembly with authentic tactile action. Finish: Supplied raw and unpainted for custom finishing. Fulfillment: In stock; items are built to order. Price shown: 130.00 Australian dollars on the consulted page. |