Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €257.00 | From £14.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | The ADF737 is a full-scale Boeing 737 ADF panel replica used as an expansion module for CPflight MCP737 units. It provides ADF frequency displays, concentric encoders, ADF/ANT selection, TFR controls, and panel backlighting through a direct daisy-chain connection. | A DIY Boeing 737 multi-radio panel kit for simulator cockpit builders. Depending on the selected option, it may include panel parts, a PCB, electrical components, displays, resin parts, or a complete panel set, while requiring builder-supplied electronics in some configurations. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Microsoft Flight Simulator: 2020–2024 Prepar3D: Generic version stated Project Magenta: Supported ProSim737: Supported PMDG737NGX (NGXu): Supported iFly737 NG e MAX: Supported X-Plane: 11–12 using Midwest737 Simulation Zibo737 NG: Supported | Not specified |
| Connections | Daisy-chain connection: 5-pin cable; one 70 cm cable included | Not specified |
| Software requirements | Driver installation: Not required Software configuration: Not required | Simulator/add-on verification: PMDG737 and X-Plane support not yet verified |
| Physical requirements | Required host hardware: CPflight MCP737EL, MCP737PRO, or MCP737PRO2; the product page also states any CPflight MCP version is required | Configuration-dependent electronics: The Complete Set requires an Arduino or Breakout Board; Arduino is not included with the PCB + Electrical Components option. |
| Hardware compatibility | CPflight MCP737: MCP737EL, MCP737PRO, MCP737PRO2, or other CPflight MCP version | LED connection type: Standard cathode LEDs; LEDs must connect to Arduino digital/analogue pins and are not compatible with BOB shift-register outputs. |
| Simulator add-on compatibility | Project Magenta: Supported ProSim737: Supported PMDG737NGX (NGXu): Supported iFly737 NG e MAX: Supported Midwest737 Simulation: Required for stated X-Plane 11–12 compatibility Zibo737 NG: Supported | PMDG 737: Not yet verified |
| Dimensions & details | ||
| Product dimensions | Depth behind panel: 20 mm | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | Panel format: Full-scale Boeing 737 ADF panel replica Display: Five yellow active-frequency digits and five yellow standby-frequency digits Controls: Dual concentric encoders with powder-coated aluminum knobs Backlighting: Warm-white LED backlighting; yellow digits ADF selection: Jumper selection for ADF1 or ADF2 functionality TFR controls: TFR buttons can swap standby and active frequencies Included hardware: One 70 cm 5-pin connection cable included; aluminum fasteners, screws, and nuts | Product type: DIY kit with selectable configurations Radio presets: VHF1, VHF2, VHF3, HF1, HF2, and AM Available options: Complete Set; Panel Set; PCB Only; PCB + Electrical Components; Resin Parts Assembly: Minimal through-hole soldering is required. Resin parts contents: Knobs, Dzus fasteners, and spacers Dzus fasteners: Four replica fasteners are included without screws; M4 x 14 mm countersunk black screws are recommended. Listed price: From £14.00 sale price |