Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | $2.95 | €30.00 €40.00 |
| Availability | In stock | Not specified |
| CockpitSquare overview | A CD74HC4067-based breakout board that multiplexes or demultiplexes up to 16 bidirectional analog or digital channels. It is intended for DIY electronics projects requiring sensor, TTL serial, I2C, SPI, or similar signal routing. | A USB joystick controller board for custom flight-simulator cockpit controls. It provides six analogue axes, 20 direct button inputs, one HAT/POV switch, and standard USB HID gamepad operation for assignment in Windows and compatible simulator software. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Microsoft Flight Simulator / Prepar3D / X-Plane: Compatible as a standard USB HID game-controller device; specific simulator versions are not stated. ProSim / PMDG / Zibo: Compatible through the add-on or simulator input-assignment system; named-function availability depends on the add-on. |
| Connections | Not specified | USB: USB 2.0 Full-Speed, 12 Mbps; presented as a USB HID gamepad. IDC Connectors: The product page states that the board is ready to be connected using IDC connectors. |
| Software requirements | Not specified | Windows: Windows 7, Windows 10, and Windows 11 are listed as compatible on the product page; the manual specifically documents Windows 10/11 verification. Arduino IDE: Required for firmware development or reloading according to the manual. |
| Physical requirements | Supply voltage: 2V to 6V operation | Analogue controls: Potentiometers are required for the six analogue inputs and must use a 3.3 V reference and common ground. Digital controls: External switches or buttons connect the direct inputs to ground; the HAT/POV inputs also switch to ground. USB data cable: A data-capable USB cable is required for USB operation or troubleshooting. |
| Hardware compatibility | Not specified | Not specified |
| Simulator add-on compatibility | Not specified | Input protocol: Standard USB HID axes, buttons, and HAT data; simulator or add-on mapping is required. |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Not specified | Not specified |
| Additional factual details | Multiplexer channels: 16 channels; routes the common signal pin to one of 16 channel pins Signal types: Supports analog and digital signals; signal voltage must not exceed VCC Control interface: Uses four digital address-select inputs, S0-S3; up to 16 sensors can be connected using five pins Signal routing: Bidirectional switching; suitable for TTL-level serial data and potentially I2C or SPI arrangements On resistance: 70 Ohms at 4.5V Switching behavior: 6ns break-before-make at 4.5V Operating temperature: -55C to 125C Enable control: Enable pin can disconnect the common pin when driven high Package contents: One CD74HC4067 16-channel analog/digital MUX breakout board | Analogue axes: 6 axes; the product page states 10-bit resolution, while the manual specifies 12-bit raw ADC input for the documented firmware. Direct button inputs: 20 direct button inputs. HAT / POV: 1 HAT/POV switch, reported as an eight-direction control in the manual. USB report rate: Approximately every 4 ms, around 250 Hz, according to the manual. Calibration: Firmware-based calibration stored in non-volatile memory. Reference: S7NG-GEN-B-NL-A20-2808. Product version: V2; the product page lists Version V1, apparently referring to the listed firmware or data-sheet entry. |