Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | €22.90 | CHF 55.00 |
| Availability | In stock | Not specified |
| CockpitSquare overview | A USB HID controller board for connecting GNX modules to a PC. It provides USB 2.0 Type-C connectivity, firmware updates, onboard profile storage, and optional programming software, and is supplied with mounting hardware and a USB cable. | A fifth-generation USB main printed circuit board intended as an electronic replacement or control component for a compatible flight-simulation hardware setup. The product page identifies it as a standalone PCB and lists a price excluding VAT. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | USB: USB 2.0 HID via USB Type-C USB: USB Type-C cable, 180 cm / 6 ft included | Interface: USB |
| Software requirements | Operating-system input support: MS Windows DirectInput; controller limits are described for Windows Configuration software: Optional programming software is available for advanced users; firmware and software are provided through the seller-linked downloads section | Not specified |
| Physical requirements | PC connection: Required to provide USB connectivity for GNX modules to a PC GNX module interconnection: GNX modules normally interconnect by BUS cable; this controller is used when connecting the configuration to a PC | Not specified |
| Hardware compatibility | GNX THQ/V: Explicitly listed as compatible GNX FSM-GA: Explicitly listed as compatible GNX SEM/V: Explicitly listed as compatible GNX module configurations: Supports additional USB controllers when the configuration exceeds 8 or 16 axes | Not specified |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Product weight: 75 g | Not specified |
| Additional factual details | Controller platform: NJoy32 platform Processor architecture: 32-bit ARM controllers inside base and grip Installation: Plug-and-play and driver-free installation is recommended for most users Firmware: Firmware upgrade via USB Profile storage: Onboard memory for storing profiles Included contents: PCB board, set of screws, USB Type-C cable, and transparent rubber lens Warranty: 2 years Axis scaling: One controller is required for configurations with 9–16 axes; another is required for 17–24 axes Stock status: In stock at the time the page was read | Listed price: USD $63.80 ex VAT |