Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | $2.95 | €22.90 |
| Availability | In stock | In stock |
| CockpitSquare overview | A CD74HC4067-based breakout board that multiplexes or demultiplexes up to 16 bidirectional analog or digital channels. It is intended for DIY electronics projects requiring sensor, TTL serial, I2C, SPI, or similar signal routing. | A USB HID controller board for connecting GNX modules to a PC. It provides USB 2.0 Type-C connectivity, firmware updates, onboard profile storage, and optional programming software, and is supplied with mounting hardware and a USB cable. |
| Aircraft | Not specified | Not specified |
| Aviation category | Universal / Generic | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Not specified | USB: USB 2.0 HID via USB Type-C USB: USB Type-C cable, 180 cm / 6 ft included |
| Software requirements | Not specified | Operating-system input support: MS Windows DirectInput; controller limits are described for Windows Configuration software: Optional programming software is available for advanced users; firmware and software are provided through the seller-linked downloads section |
| Physical requirements | Supply voltage: 2V to 6V operation | PC connection: Required to provide USB connectivity for GNX modules to a PC GNX module interconnection: GNX modules normally interconnect by BUS cable; this controller is used when connecting the configuration to a PC |
| Hardware compatibility | Not specified | GNX THQ/V: Explicitly listed as compatible GNX FSM-GA: Explicitly listed as compatible GNX SEM/V: Explicitly listed as compatible GNX module configurations: Supports additional USB controllers when the configuration exceeds 8 or 16 axes |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Not specified |
| Product weight | Not specified | Product weight: 75 g |
| Additional factual details | Multiplexer channels: 16 channels; routes the common signal pin to one of 16 channel pins Signal types: Supports analog and digital signals; signal voltage must not exceed VCC Control interface: Uses four digital address-select inputs, S0-S3; up to 16 sensors can be connected using five pins Signal routing: Bidirectional switching; suitable for TTL-level serial data and potentially I2C or SPI arrangements On resistance: 70 Ohms at 4.5V Switching behavior: 6ns break-before-make at 4.5V Operating temperature: -55C to 125C Enable control: Enable pin can disconnect the common pin when driven high Package contents: One CD74HC4067 16-channel analog/digital MUX breakout board | Controller platform: NJoy32 platform Processor architecture: 32-bit ARM controllers inside base and grip Installation: Plug-and-play and driver-free installation is recommended for most users Firmware: Firmware upgrade via USB Profile storage: Onboard memory for storing profiles Included contents: PCB board, set of screws, USB Type-C cable, and transparent rubber lens Warranty: 2 years Axis scaling: One controller is required for configurations with 9–16 axes; another is required for 17–24 axes Stock status: In stock at the time the page was read |