Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €10.00 | €109.00 |
| Availability | In stock | Not specified |
| CockpitSquare overview | A white silicone cap designed to fit over compatible toggle switches used in Boeing 737-style simulator cockpit panels. It is intended for home cockpit, DIY panel, and flight simulation projects; switches and electronic modules are sold separately. | A panel-mount, three-position toggle switch with magnetically held momentary positions, solenoid control circuitry, and SPDT contacts. It is intended for flight-simulation cockpits, panels, and DIY or microcontroller-based simulator projects. |
| Aircraft | 737 | Not specified |
| Aviation category | Airliners | Universal / Generic |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Not specified | Terminal connector: 6P 2.0 mm DIP header with PH connector; supplied with a 15 cm wire-to-board connector |
| Software requirements | Not specified | Not specified |
| Physical requirements | Compatible toggle switch: The cap fits over compatible toggle switches; buyers should check switch dimensions before purchase. | Power supply: Variant-dependent: 5.0–5.5 V DC for the 5 V variant, or 12 V DC ±5% for the 12 V variant Panel mounting: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm and recommended minimum 1.5 mm Electrical installation: Requires DC wiring, shared ground with the interface or microcontroller, ARM control input(s), and pull-up resistor(s) for ON1/ON2 outputs |
| Hardware compatibility | Toggle switch dimensions: Compatibility depends on the dimensions of the user's toggle switches. | Microcontroller-based simulator systems: Suitable for MobiFlight and similar microcontroller-based systems; interface-specific suitability must be evaluated by the user Opencockpits IOCards: Potentially incompatible because the solenoid and switch circuits share the same ground |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Mounting and panel dimensions: M12 × 0.75 mm threaded bushing; maximum panel thickness 5 mm; recommended minimum panel thickness 1.5 mm; throw angle 2 × 18° Operating temperature: 0–40 °C |
| Product weight | Not specified | Not specified |
| Additional factual details | Material: Silicone Color: White Available quantity options: 10-piece set, 20-piece set, or 50-piece set Included items: Silicone switch caps only Excluded items: Toggle switches, panels, and electronic modules are not included. Intended applications: Boeing 737-style cockpit panels, overhead panels, MIP, pedestal, custom switch panels, home cockpits, MobiFlight, DIY cockpit, and flight simulation panel projects. Aircraft-part status: Designed for Boeing 737-style simulation projects and is not an original aircraft part. SKU: B737-SILICONE-SWITCH-CAP | Switch function: The listed standard configuration, part 10-301, uses (ON)-OFF-(ON): the center position is maintained and both outer positions are momentary, spring-loaded, and magnetically held. Electrical contacts: Single Pole Double Throw (SPDT) contacts; microswitch contact rating DC 30 V, 0.1 A. Solenoid control: Two holding solenoids are independently controlled through ARM1 and ARM2 inputs; each solenoid position releases when its ARM input returns LOW. Mechanical life: Minimum 10,000 cycles. Product status: The product page marks the item out of stock. Reference: Reference/part number 10-301 is shown for the standard switch configuration. Safety and intended use: For indoor, DC-powered simulator and DIY applications; not designed, tested, or certified for real aircraft flight-deck equipment or safety-critical systems. |