Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €30.00 | From $450.00 |
| Availability | In stock | In stock |
| CockpitSquare overview | A Boeing 737 stabilizer-trim panel replica for flight simulation and pilot-training cockpit setups. Depending on the selected version, it is supplied as a panel-only assembly, a programmable unit requiring a controller board, or a pre-programmed USB-ready unit. | A 1:1-scale A320 simulator panel reproducing rudder-trim and parking-brake controls. The metal-button and metal-handle unit connects through an RJ45 interface and requires a CAN box for USB connection to a computer, with iFSim.Ready listed as required. |
| Aircraft | 737 | A320 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Microsoft Flight Simulator: Generic MSFS support is stated for the plug-and-play version; the page does not specify MSFS 2020 or MSFS 2024. | Not specified |
| Connections | IDC: IDC connector on the rear PCB; pin layout information is provided on the PCB or in a datasheet. USB: Available for the plug-and-play version, which is described as USB-ready. 12V power: Separate 12-volt connection for backlighting; a single-panel product does not include a 12V adapter. | Panel interface: RJ45 Computer connection: USB via CAN box |
| Software requirements | Configuration files: Required for the plug-and-play version. Programming: Required for the Connect and Play version. Calibration: Calibration is required through software or firmware where applicable to gauges. | Required software: iFSim.Ready |
| Physical requirements | Controller board: Required for the Connect and Play version. 12V power adapter: Required for backlighting but not included with a single-panel product. | CAN box: Required to convert the RJ45 interface to USB for computer connection |
| Hardware compatibility | Controller boards: The Connect and Play version connects to a controller board through the rear IDC pins. | Not specified |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Listing dimensions: 2 × 15 × 4 cm Panel face dimensions: 146 mm × 57 mm | Not specified |
| Product weight | Weight: 0.1 kg | Not specified |
| Additional factual details | Construction: Two acrylic layers: a 3 mm lower layer and a 5 mm upper front sheet. Finish: Painted in Boeing gray, RAL 7011 / iron gray. Included panel components: The panel-only set includes front and back panels, annunciators, knobs, and switch guards; electronic components are excluded. Backlighting: Warm-white backlighting is provided for the buttons and panel. Available versions: The listing describes Panel Only, Connect and Play, and Plug and Play variants. Knobs: Resin 3D-printed knobs with D-shaft fittings. | Scale and layout: 1:1-scale replica matching the actual aircraft's size and layout Materials: Buttons and handles are made of metal CAN box sharing: One CAN box can support all CnTech pedestal components; a second is not needed if the customer already purchased CnTech's Throttle Quadrant Warranty: 1-year limited warranty Availability: Sold out on the consulted product page |