Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | $2.95 | €60.50 |
| Availability | In stock | Not specified |
| CockpitSquare overview | A CD74HC4067-based breakout board that multiplexes or demultiplexes up to 16 bidirectional analog or digital channels. It is intended for DIY electronics projects requiring sensor, TTL serial, I2C, SPI, or similar signal routing. | A fully assembled printed-circuit-board baseplate for the center side of a Boeing 737NG Main Instrument Panel simulator. It provides connectors for associated modules, annunciators, landing-gear controls, backlighting, and companion MIP baseplates. |
| Aircraft | Not specified | 737 |
| Aviation category | Universal / Generic | Airliners |
| Compatibility & connections | ||
| Supported simulators | Not specified | Not specified |
| Connections | Not specified | IDC connectors: Connectors for Sismo EDC modules and companion MIP baseplates Power input: +12 Vcc supplied from the CAIP/Captain-side baseplate |
| Software requirements | Not specified | Not specified |
| Physical requirements | Supply voltage: 2V to 6V operation | Required companion hardware: Must be connected to the MIP Captain Side Electronic Baseplate; compatible connections are also provided for the MIP F/O Side Electronic Baseplate. Power supply: No separate power supply is needed when used with the Captain-side baseplate. |
| Hardware compatibility | Not specified | Sismo EDC module: Connector provided for the EDC Module of Sismo Landing gear lever: Connector provided MIP annunciators: Connectors provided for center MIP annunciators |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Not specified | Approximate dimensions: 19 × 7.5 cm (width × height) |
| Product weight | Not specified | Not specified |
| Additional factual details | Multiplexer channels: 16 channels; routes the common signal pin to one of 16 channel pins Signal types: Supports analog and digital signals; signal voltage must not exceed VCC Control interface: Uses four digital address-select inputs, S0-S3; up to 16 sensors can be connected using five pins Signal routing: Bidirectional switching; suitable for TTL-level serial data and potentially I2C or SPI arrangements On resistance: 70 Ohms at 4.5V Switching behavior: 6ns break-before-make at 4.5V Operating temperature: -55C to 125C Enable control: Enable pin can disconnect the common pin when driven high Package contents: One CD74HC4067 16-channel analog/digital MUX breakout board | Product type: Fully assembled printed circuit board with components installed Backlighting connection: Connector provided for 12 V backlighting Flat ribbon cables: Not included Version: V3.6 Reference: S7NG-MIP-B-AL-A35-0177 Included item: One fully assembled baseplate Documentation: Datasheet and SC-MB configuration manual are available on the product page |