Compare Hardware
Compare the details. Find your fit.
2 productsSide-by-side comparison |
|---|
AI insights
| Buyer advice | Preparing AI insights | |
|---|---|---|
| Overview | ||
|---|---|---|
| Price | From €25.00 | From £12.12 |
| Availability | In stock | In stock |
| CockpitSquare overview | A Boeing 737 overhead stall-warning panel replica for flight simulator cockpit builds. Depending on the selected variant, it is sold as a panel-only assembly, a programmable unit requiring a controller board, or a pre-programmed USB-ready version. | A DIY Boeing 737 six-pack display component product comprising selectable PCB and lens configurations. Depending on the selected option, it provides LED backlighting, ALPS soft-press switches, and engraved lenses for constructing 737 cockpit display units. |
| Aircraft | 737 | 737 |
| Aviation category | Airliners | Airliners |
| Compatibility & connections | ||
| Supported simulators | Simulator software: Preferred flight simulation software; specific simulator names are not stated | Not specified |
| Connections | IDC: IDC connector on the rear PCB; Connect and Play variant uses IDC connector pins to connect to a controller board USB: Plug and Play variant is USB-ready | Not specified |
| Software requirements | Configuration files: Plug and Play variant requires installation of provided configuration files Programming: Connect and Play variant requires programming; calibration may be required through software or firmware where applicable | Not specified |
| Physical requirements | Controller board: Required for the Connect and Play variant 12V power adapter: Not included with single-panel products; used for backlighting, with one adapter required for a daisy-chained cockpit setup | Not specified |
| Hardware compatibility | Controller boards: Compatible with a controller board through the rear PCB IDC connector; no specific board model is stated | Pokeys card: Explicitly listed as suitable for the Common Anode PCB version. Arduino: Explicitly listed as suitable for the Common Ground PCB version using digital pins. Karl’s Breakout Board (BOB): Supported with the Common Anode and Common Ground PCB versions, with different interface arrangements. |
| Simulator add-on compatibility | Not specified | Not specified |
| Dimensions & details | ||
| Product dimensions | Listed product dimensions: 2 × 16 × 4 cm Detailed panel dimensions: 146 mm × 48 mm Material thickness: 5 mm acrylic sheet | Not specified |
| Product weight | Weight: 0.1 kg | Not specified |
| Additional factual details | Product type: Stall-warning panel replica for a Boeing 737 overhead cockpit environment Construction and finish: Acrylic panel painted Boeing gray RAL 7011 Controls and indicators: Includes annunciators, annunciator boxes, push buttons, rotary knobs, and labeling; exact contents depend on the selected variant Panel Only variant: Includes front and back panels, annunciators, knobs, and switch guards; electronic components are excluded Connect and Play variant: Fully functional unit requiring connection to a controller board and programming Plug and Play variant: Pre-programmed and USB-ready; configuration files must be installed Power behavior: The power supply is used solely for backlighting, not core functions | Product configuration: The product page offers a complete DIY set, PCB-only options, and lens options with or without non-slip film. Complete DIY set contents: The complete set includes two switch PCBs, two LED PCBs, and two FO & CPT lenses with non-slip film. Switches: The switch backplate uses four ALPS soft-press buttons. LEDs: The LED backplate provides two LEDs per caption; the listed LEDs are white SMD LEDs. Lenses: Lenses are made from 3 mm orange perspex and may include non-slip film. PCB variants: Common Anode and Common Ground PCB versions are offered. The Common Ground version includes onboard resistors for 5 V operation. Build files: STL build files are available through the linked build guide. Listed price: The page lists a sale price from £12.12, depending on product selection. |